Chapter 2: Front panel programming
124 Vigilant VS1 and VS2 Technical Reference Manual
To program loop events:
1. Press the Menu button and choose Programming.
2. Choose Advanced Program and enter the level 2
password.
3. Choose Loop Events.
4. Select the loop event.
5. Choose Event Notification.
6. Set the event notification. See the default settings in
the table above.
Printer: Yes or No. Specifies if event information is
printed
Dialer:
Acct 1 & 2: Event information is sent to both dialer
accounts
Acct 1: Event information is sent to dialer account
one
Acct 2: Event information is sent to dialer account
two
None: Event information is not sent to the dialer
NET: Yes or No. Specifies if event information is sent
to the connected network
CID: Contact ID event code (000 to 999)
7. When finished, choose Save.
8. Repeat steps 6 to 9 for each loop event.
9. Press the Menu button to exit menu mode, or
continue programming.
Advanced Program
Panel Operation
Panel Events
Loop Events
⇩
Loop Events
Loop 1 Initializing
Loop 1 Fault
Loop 1 Map Fault
Loop 1 Initializing
Event Notification
⇩
Trouble
Printer Yes<>
Dialer Account 1&2
NET Yes<>
⇩
Trouble
NET Yes<>
CID 110
To Next Page
Loading...
