GE Security Vigilant VS2 User Manual

Chapter 3: System operation
Vigilant VS1 and VS2 Technical Reference Manual 147
Event ID Event description Event ID Event description
005 Loop 1 uncfgrd trouble: A device on
loop 1 that is not programmed went
into trouble
057 Net recvr config fault: The panel
failed to communicate with the
network receiver after a
configuration change
006 Loop 1 map mismatch: The loop 1
map in RAM and the loop 1 map in
the database do not match
058 NAC 1 trouble: An open or short has
been detected on NAC 1 or there is a
problem with the EOL
007 Loop 1 over limits: There are too
many devices on loop 1
059 NAC 2 trouble: An open or short has
been detected on NAC 2 or there is a
problem with the EOL
008 Loop 1 device 000: A device on loop
1 has an address set to zero
060 NAC 3 trouble: An open or short has
been detected on NAC 3 or there is a
problem with the EOL
009 Loop 1 mapping: Loop 1 is mapping
devices
061 NAC 4 trouble: An open or short has
been detected on NAC 4 or there is a
problem with the EOL
010 Loop 2 initialization: Loop 2 is
starting up
062 Printer trouble: The printer is either
offline, out of paper, or disconnected
011 Loop 2 fault: A short or open was
detected on loop 2 affecting the
communications between the panel
and the devices on the loop
063 Annunciator 1 trouble: An open or
short has been detected on
annunciator 1
012 Loop 2 map fault: A mapping fault
was detected on loop 2 while the
panel was mapping the devices
064 Annunciator 2 trouble: An open or
short has been detected on
annunciator 2
013 Loop 2 card fault: The loop 2 card is
not present or it is not working
properly
065 Annunciator 3 trouble: An open or
short has been detected on
annunciator 3
014 Loop 2 uncfgrd alarm: A device on
loop 2 that is not programmed went
into alarm
066 Annunciator 4 trouble: An open or
short has been detected on
annunciator 4
015 Loop 2 uncfgrd trouble: A device on
loop 2 that is not programmed went
into trouble
067 Annunciator 5 trouble: An open or
short has been detected on
annunciator 5
016 Loop 2 map mismatch: The loop 2
map in RAM and the loop 2 map in
the database do not match
068 Annunciator 6 trouble: An open or
short has been detected on
annunciator 6
017 Loop 2 over limits: There are too
many devices on loop 2
069 Annunciator 7 trouble: An open or
short has been detected on
annunciator 7
018 Loop 2 device 000: A device on loop
2 has an address set to zero
070 Annunciator 8 trouble: An open or
short has been detected on
annunciator 8

GE Security Vigilant VS2 Specifications

General

Brand	GE Security
Model	Vigilant VS2
Category	Control Panel
Language	English