GE Security Vigilant VS2 - Page 160

Chapter 3: System operation
148 Vigilant VS1 and VS2 Technical Reference Manual
Event ID Event description Event ID Event description
019 Loop 2 mapping: Loop 2 is mapping
devices
071 Zone 1 (active, trouble, disable,
prealarm, alarm verify, maintenance
alert, or test has been detected on
zone 1)
020 System startup: The control panel is
starting up
072 Zone 2 (active, trouble, disable,
prealarm, alarm verify, maintenance
alert, or test has been detected on
zone 2)
021 Program mode: The control panel is
in program mode
073 Zone 3 (active, trouble, disable,
prealarm, alarm verify, maintenance
alert, or test has been detected on
zone 3)
022 Reset: The control panel is resetting 074 Zone 4 (active, trouble, disable,
prealarm, alarm verify, maintenance
alert, or test has been detected on
zone 4)
023 Reset/Sil inhibit: Reset/silence inhibit
is activated
075 Zone 5 (active, trouble, disable,
prealarm, alarm verify, maintenance
alert, or test has been detected on
zone 5)
024 Panel silence: The control panel
buzzer has been silenced
076 Zone 6 (active, trouble, disable,
prealarm, alarm verify, maintenance
alert, or test has been detected on
zone 6)
025 Signal silence: The control panel
NACs have been silenced
077 Zone 7 (active, trouble, disable,
prealarm, alarm verify, maintenance
alert, or test has been detected on
zone 7)
026 Drill: The control panel is in the drill
state
078 Zone 8 (active, trouble, disable,
prealarm, alarm verify, maintenance
alert, or test has been detected on
zone 8)
027 Walk test: The control panel is in the
walk test state
079 Zone 9 (active, trouble, disable,
prealarm, alarm verify, maintenance
alert, or test has been detected on
zone 9)
028 Test fire: A smoke or heat detector is
being tested
080 Zone 10 (active, trouble, disable,
prealarm, alarm verify, maintenance
alert, or test has been detected on
zone 10)
029 Clear history: The control panel’s
event history has been cleared
081 Zone 11 (active, trouble, disable,
prealarm, alarm verify, maintenance
alert, or test has been detected on
zone 11)