page | 110
Basic Operation
Menu System
10. Press the OK button to save the current changes.
11. The following screen will be displayed, momentarily:
12. Continue by pressing the ▲ or ▼ buttons to select the Subnet Mask setting.
The subnet mask address will be displayed.
13. Press the OK button to change the setting. The rst digit of the subnet mask will ash.
please reboot unit
to apply changes
Important
Any time a setting has been changed, the “please reboot unit” message will
be displayed. However, it is not required to reboot the unit until all desired
changes have been made. All changed settings are “saved” but will only be
applied once the unit is rebooted.
subnet mask:
_55.255.0.000
LAN
POE
5V DC
1 2
Matrix Controller
Status
IR
Power
Menu
1 2 3
4 5 6
7 8 9
In 0 Out Set
Clear
Mask
Preset
Back
OK
Lock
subnet mask:
255.255.255.0
OR
Basic Operation
To Next Page
Loading...
Need help?
General