page | 121
Basic Operation
Menu System
13. If an error is made, use the ◄ or ► to move backward or forward between each digit.
14. Press the OK button to save the change.
15. Press the ▲ or ▼ button to select the Remote UDP Access setting.
16. Press the OK button, again, to edit the setting.
17. Press the ▲ or ▼ buttons to select either Enabled or Disabled.
If this option is set to Enabled, then remote UDP access will be permitted.
Otherwise, set this option to Disabled to prohibit access using the UDP protocol.
18. Press the OK button to save the changes.
remote udp access
disabled
remote udp access: E
disabled
remote udp access:
Enabled
LAN
POE
5V DC
1 2
Matrix Controller
Status
IR
Power
Menu
1 2 3
4 5 6
7 8 9
In 0 Out Set
Clear
Mask
Preset
Back
OK
Lock
udp PORT: (edit)
5000_
OR
To Next Page
