Gefen EXT-CU-LAN - Page 31

page | 19
To the right of the IP address and MAC address, the Description and User elds
are displayed. The Description eld can be changed as desired. For example,
we could change this eld to “EXT-CU-LAN Slave” for easy identication by the
Gefen Syner-G software.
Notes and restrictions on using slave Matrix Controllers:
► Users with Slave access level do not have access to the menu system on the
front panel. To allow access to the menu system on a slave unit, add the front
panel user.
► Additional time may be required for a slave Matrix Controller to register changes
within the system. This includes adding new users and connecting KVM over
IP-based products to the network.
► If a KVM over IP-based product is removed from the system, it is recommended
to click the Refresh button under the System > Slave Cong tab of the master
Matrix Controller.
► To switch a slave Matrix Controller to a master, the slave Matrix Controller
must be reset to factory-default settings. Click the Reset button under the
System > Basic Settings tab of the slave Matrix Controller.
Getting Started
Installation