Genesis G70 - Resetting the System

5
5-29
Information
• If you press the SET button or the
corresponding button which the setting
is being recalled, the setting will
temporarily deactivate. If you press the
other buttons, the setting of the
pressed button will activate.
For example, if you press the SET
button or number 1 button with the
number 1 setting in operation, the
setting will temporarily deactivate. If
you press the number 2 button, the
number 2 setting will activate.
• If you adjust the seat, side view mirror,
steering wheel, instrument panel
illumination or head-up display while
recalling the stored positions, the
pre-set settings will become
ineffective.
Resetting the system
Take the following procedures to reset
integrated memory system, when it does
not operate properly.
Resetting integrated memory
system
1. Stop the vehicle and open the driver's
door with the engine on and the vehicle
shifted to P (Park).
2. Adjust the driver's seat and seatback to
the foremost position.
3. Press the SET button and push forward
the driver's seat switch simultaneously
(about two seconds).
4. Release the SET button and the driver's
seat switch when a beep sounds.
While resetting integrated memory
system
1. Resetting starts with a notification
sound.
2. The driver's seat and seatback is
adjusted to the rearward position with
the notification sound.
3. The driver's seat and seatback is
re-adjusted to the default position
(central position) with the notification
sound.
However, in the following cases, the
resetting procedure and the notification
sound may stop.
• The memory button is pressed.
• The seat control switch is operated.
• The gear is shifted out of P (Park).
• The driving speed exceeds 2 mph (3
km/h).
• The driver's door is closed.
NOTICE
• While integrated memory system is
being reset, if the resetting and
notification sound stops incompletely,
restart the resetting procedure again.
• Make sure that there are no objects
around the driver's seat in advance of
resetting the integrated memory
system.
• After resetting the integrated memory
system, the adjustment for the driver
seat must be stored again to recall the
memory position.
0_IK_PE_en_US.book Page 29