8-28
Emergency situations
Removable towing hook
1. Open the trunk, and remove the towing
hook from the tool case.
Front
OIK083017L
Rear
OIK083019
2. Remove the hole cover by pressing the
lower part of the cover on the bumper.
3. Install the towing hook by turning it
clockwise into the hole until it is fully
secured.
4. Remove the towing hook and install the
cover after use.
Emergency towing
Front
OIK083018L
Rear
OIK083020
If towing is necessary, contact an
authorized retailer of Genesis Branded
products or a commercial tow-truck
service.
If towing service is not available in an
emergency, your vehicle may be
temporarily towed using a cable or chain
secured to the emergency towing hook at
the front (or rear) of the vehicle.
Use extreme caution when towing the
vehicle with a cable or chain. A driver
must be in the vehicle to steer it and
operate the brakes.
Towing in this manner may be done only
on hard-surfaced roads for a short
distance and at low speeds. Also, the
wheels, axles, power train, steering and
brakes must all be in good working
condition.
0_IK_PE_en_US.book Page 28
To Next Page
Loading...
