5-98
Convenience features
if equipped
Automatic Dehumidify
To increase cabin air quality and reduce
windshield misting, recirculation mode
switches off automatically after about 5
to 30 minutes, depending on the outside
temperature, and the air intake will
change to fresh mode.
Turning Automatic Dehumidify ON
or OFF
Climate control system
To turn the Auto Dehumidify feature on or
off, select Face level ( ) mode and
press the air intake control ( ) button
at least five times within three seconds.
When Auto Dehumidify is turned on, the
air intake control button indicator will
blink 6 times. When turned off, the
indicator will blink 3 times.
Infotainment system
Auto Dehumidify can be turned on and off
by selecting Setup > Vehicle > Climate >
Automatic Ventilation > Automatic
Dehumidify from the Settings menu in
the infotainment system.
Recirculating air when washer
fluid is used
Recirculation mode automatically
activates to reduce any objectionable
scent of the washer fluid from entering
the cabin when the windshield washer is
used.
Turning Activate upon Washer Fluid
Use ON or OFF
Climate control system
To turn the Activate upon Washer Fluid
Use feature on or off, select Floor level
( ) mode, and then press the air intake
control ( ) button 5 times within 3
seconds while pressing the A/C icon.
When Activate upon Washer Fluid Use ON
is turned on, the air intake control button
indicator will blink 6 times. When turned
off, the indicator will blink 3 times.
Infotainment system
Activate upon Washer Fluid Use can be
turned on and off by selecting Setup >
Vehicle > Climate > Recirculate Air >
Activate upon Washer Fluid Use from the
Settings menu in the infotainment
system.
However, in cold weather to prevent the
windshield from fogging up, the
recirculation mode may not be selected.
Recirculating air when
if equipped
entering a tunnel
To prevent the inflow of polluted air into
the vehicle when passing through a
tunnel, this function automatically closes
the windows and switches the climate
control system to Recirculation mode for
about 7 seconds before entering a tunnel
based on the map information of the
navigation and the speed of the vehicle.
To prevent the inflow of polluted air into
the vehicle when passing through a
tunnel, the windows and climate control
system are operated using the navigation
map information and vehicle speed as
follows:
To use this feature, it must be enabled
from the Settings menu in the
infotainment system. Select: Setup >
Vehicle > Climate > Recirculate Air
0_IK_PE_en_US.book Page 98