5-80
Convenience features
To avoid personal injury from the
windshield wipers, when the engine is
running and the windshield wiper switch
is placed in the AUTO mode:
• Do not touch the upper end of the
windshield glass facing the rain sensor.
• Do not wipe the upper end of the
windshield glass with a damp or wet
cloth.
• Do not put pressure on the windshield
glass.
• When washing the vehicle, set the
wiper switch in the OFF position to stop
the auto wiper operation. The wiper
may operate and be damaged if the
switch is set in the AUTO mode while
washing the vehicle.
• Do not remove the sensor cover
located on the upper end of the
passenger side windshield glass.
Damage to system components could
occur and may not be covered by your
vehicle warranty.
• Because of using a photo sensor,
temporary malfunction could occur
according to sudden ambient light
change made by stone and dust while
driving.
Front windshield washers
OIK053318
In the OFF position, pull the lever gently
toward you to spray washer fluid on the
windshield and to run the wipers 1-3
cycles. The spray and wiper operation will
continue until you release the lever. If the
washer does not work, you may need to
add washer fluid to the washer fluid
reservoir.
Recirculating air when washer fluid
is used
When washer fluid is used, in order to
reduce any objectionable scent of the
washer fluid from entering the cabin,
recirculation mode and air conditioning
are automatically activated depending on
the outside temperature. If you select
fresh mode while the function is
operating, the function will resume after a
certain amount of time. It may not work in
some conditions such as cold weather or
engine OFF.
For more information, refer to the
"Climate Control Additional Features"
section in this chapter.
0_IK_PE_en_US.book Page 80
To Next Page
Loading...
