7-52
Driver assistance system
Blind-Spot View Monitor
operation
Blind-Spot View Monitor will turn on and
off when the turn signal is turned on and
off.
OIK073176
Operating conditions
When the left or right side turn signal
turns on, the image in that direction
appears on the instrument cluster.
Off conditions
• When the turn signal turns off, the
image on the instrument cluster will
turn off.
• When the hazard warning flasher is on,
Blind-Spot View Monitor will turn off,
regardless of the turn signal status.
• When other important warning appears
on the instrument cluster, Blind-Spot
View Monitor may turn off.
Blind-Spot View Monitor
malfunction
When Blind-Spot View Monitor is not
working properly, or the cluster display
flickers, or the camera image does not
display properly, have your vehicle
inspected by an authorized retailer of
Genesis Brand products.
• The image shown on the instrument
cluster may differ from the actual
distance of the object. Make sure to
directly check the vehicle's
surroundings for safety.
• Always keep the wide-side view
camera lens clean. If the lens is covered
with foreign material, it may adversely
affect camera performance and
Blind-Spot View Monitor may not
operate properly. However, do not use
chemical solvents such as strong
detergents containing high alkaline or
volatile organic solvents (gasoline,
acetone etc.). This may damage the
camera lens.
0_IK_PE_en_US.book Page 52
To Next Page
Loading...
Need help?
General
