Genesis G70 - Auto Hold

6-28
Driving your vehicle
Auto Hold
Auto Hold helps maintain the vehicle in a
standstill even though the brake pedal is
not depressed after the driver brings the
vehicle to a complete stop by depressing
the brake pedal.
Information
The Auto Hold On or Off setting is
maintained when the vehicle is turned off.
When the vehicle is restarted the last
setting for Auto Hold is applied.
To apply:
1. With the driver's door and engine hood
closed, depress the brake pedal and
then press the AUTO HOLD switch. The
white AUTO HOLD indicator will come
on and the system will be in the standby
position.
OIK063021
[A] White
2. When you stop the vehicle completely
by depressing the brake pedal, Auto
Hold maintains the brake pressure to
hold the vehicle stationary. The
indicator changes from white to green.
OIK063022
[A] White
[B] Green
3. The vehicle will remain stationary even
if you release the brake pedal.
4. If EPB is applied, Auto Hold will be
released.
To release:
• If you depress the accelerator pedal
with the gear in D (Drive), R (Reverse) or
Manual shift mode, the Auto Hold will
be released automatically and the
vehicle will start to move. The AUTO
HOLD indicator changes from green to
white.
WARNING
When Auto Hold is automatically released
by depressing the accelerator pedal,
always take a look around your vehicle.
Slowly depress the accelerator pedal for a
smooth start.
To cancel:
OIK063023
[A] Light off
0_IK_PE_en_US.book Page 28