5
5-37
3. Press the Engine Start/Stop button to
the ACC (Accessory) position for
programming of HomeLink.
2) Programming a New HomeLink®
OIK053372N
1. Press and release the HomeLink button
(1), (2) or (3), you would like to program.
The HomeLink indicator light (7) will
flash orange slowly (if not, perform the
steps of "Erasing HomeLink Buttons"
section, and start over).
OIK033206L
2. Position the garage door opener
remote 1–3 inches (2–8 cm) away from
the HomeLink buttons.
3. While the HomeLink indicator light (7) is
flashing orange, press and hold the
handheld remote button. Continue
pressing the handheld remote button
until the HomeLink indicator light (7)
light changes from orange to green.
You may now release the handheld
remote button.
4. Wait until your garage door comes to a
complete stop, regardless of position,
before proceeding to the next steps.
5. Press and release the HomeLink button
you are programming and observe the
indicator light.
• If the indicator light remains solid
green, your device should operate
when the HomeLink button is
pressed. At this point, if your device
operates, programming is complete.
• If the indicator light rapidly flashes
green, firmly press, hold for two
seconds and release the HomeLink
button up to three times in a row
slowly to complete the programming
process. Do not press the HomeLink
button rapidly. At this point if your
device operates, programming is
complete. If the device does not
operate, continue with step 6.
6.At the garage door opener motor,
(security gate motor, etc.) locate the
"Learn", "Smart", "Set" or "Program"
button. This can usually be found where
the hanging antenna wire is attached to
the motor-head unit (see the device's
manual to identify this button). The
name and color of the button may vary
by manufacturer.
2C_ECMHomelink_5
[A] Learn button
• A ladder and/or second person may
simplify the following steps.
7. Firmly press and release the "Learn",
"Smart", "Set" or "Program" button. You
now have up to 30 seconds in which to
complete the next step.
0_IK_PE_en_US.book Page 37
To Next Page
Loading...
