Genesis G70 - Page 373

7
7-57
Resuming Smart Cruise Control
OIK073040
To resume Smart Cruise Control after the
function was canceled, operate the +, - or
switch.
If you push the + switch up or - switch
down, vehicle speed will be set to the
current speed on the instrument cluster.
If you press the switch, vehicle speed
will resume to the preset speed.
WARNING
Check the driving condition before using
the switch. Driving speed may sharply
increase or decrease when you press the
switch.
Turning off Smart Cruise Control
OIK073025
To turn Smart Cruise Control off, press the
Driving Assist ( ) button.
Information
If your vehicle is equipped with Manual
Speed Limit Assist, press and hold the
Driving Assist ( ) button to turn off
Smart Cruise Control. However Manual
Speed Limit Assist will turn on.
CAUTION
Do not use the switches and buttons at
the same time. Smart Cruise Control may
not operate properly.
Display and control
You can see the status of the Smart Cruise
Control operation in the Driving Assist
view on the instrument cluster. Refer to
the "Cluster Display (Type A)", "Cluster
Display (Type B)" section in chapter 4.
Smart Cruise Control appears as below
depending on the status of the function.
Operating
OIK073043N
• When operating
(1) Whether there is a vehicle ahead and
the selected distance level
(2) Set speed
(3) Whether there is a vehicle ahead and
the target vehicle distance
0_IK_PE_en_US.book Page 57