8
8-15
4. Remove the wheel lug wrench, jack,
jack handle, and spare tire from the
vehicle.
5. Block both the front and rear of the tire
diagonally opposite of the tire you are
changing.
OIK083025L
[A] Block
6.Loosen the wheel lug nuts
counterclockwise one turn each in the
order shown below, but do not remove
any wheel lug nuts until the tire has
been raised off of the ground.
OIK083039L
7. Place the jack at the designated jacking
position under the frame closest to the
tire you are changing. The jacking
positions are plates welded to the
frame with two notches. Never jack at
any other position or part of the vehicle.
Doing so may damage the side seal
molding or other parts of the vehicle.
OIK083032L
8.Insert the jack handle into the jack and
turn it clockwise, raising the vehicle
until the tire clears the ground. Make
sure the vehicle is stable on the jack.
OIK083031L
9.Loosen the wheel lug nuts with the
wheel lug nut wrench and remove them
with your fingers. Remove the wheel
from the studs and lay it flat on the
ground out of the way. Remove any dirt
or debris from the studs, mounting
surfaces, and wheel.
10.Install the spare tire onto the studs of
the hub.
11.Tighten the lug nuts with your fingers
onto the studs with the smaller end of
the lug nuts closest to the wheel.
0_IK_PE_en_US.book Page 15
To Next Page
Loading...
