3-34
Safety system
2. Fasten the lap/shoulder belt latch into
the buckle. Listen for the distinct "click"
sound.
OIK033147
Position the release button so that it is
easy to access in case of an emergency.
3. Pull the shoulder portion of the seat belt
all the way out. When the shoulder
portion of the seat belt is fully
extended, it will shift the retractor to
the "Automatic Locking" (child
restraint) mode.
OIK033148
4. Slowly allow the shoulder portion of the
seat belt to retract and listen for an
audible "clicking" or "ratcheting"
sound. This indicates that the retractor
is in the "Automatic Locking" mode. If
no distinct sound is heard, repeat steps
3 and 4.
OIK033149
5. Remove as much slack from the belt as
possible by pushing down on the Child
Restraint System while feeding the
shoulder belt back into the retractor.
OIK033128
6.Push and pull on the Child Restraint
System to confirm that the seat belt is
holding it firmly in place. If it is not,
release the seat belt and repeat steps 2
through 6.
7. Double check that the retractor is in the
"Automatic Locking" mode by
attempting to pull more of the seat belt
out of the retractor. If you cannot, the
retractor is in the "Automatic Locking"
mode.
0_IK_PE_en_US.book Page 34