GRAPHTEC CE LITE-50 - Confirming Cutting Condition

6 DISASSEMBLY AND REASSEMBLY
CE LITE-UM-251-9370 6-14
How to reinstall the Y-exible cable guard
(1) Loosen the M3L6 TP head screw holding the Y drive belt tension arm.
Left side frame
M3L6 TP head screw
(2) Tighten the M3L6 TP head screw while pushing the Y drive belt tension arm in the direction of the
arrow to loosen the Y drive belt as shown in the gure.
(3) Reattach the Y-exible cable guard to the frame.
(4) Loosen the M3L6 TP head screw holding the Y drive belt tension arm. Re-tighten the M3L6 TP
head screw after the Y belt tension is automatically adjusted by the Y belt tension spring.