CE LITE-UM-251-9370
6 DISASSEMBLY AND REASSEMBLY
6-81
(2) Attach the pinch roller to the pinch roller shaft in the correct direction.
Pinch roller, left Pinch roller, right
(3) Insert the upper slide shaft to the carriage so that the D cut surface is on the left side, and then x
it with the M3L6 TP head screw to the right side frame.
(4) Align the two bosses with the holes in the left side frame, and x the left side frame with four M4L6
binding head screws.
Be sure to t the slide shafts to the left side frame rmly.
Make the D-cut surface
positioned forward
(5) Tighten the M3L6 TP head screws to x the slide shafts to the left side frame.
(6) Fix the pinch roller shaft to the left side frame with the pinch roller bush L and the E-ring.
(7) Reattach the other parts in the reverse order in which they were detached.
To Next Page
Loading...
