To Next Page

To Previous Page

Disassembly

Step 6

Remove the printer power cable by

pulling the cable connector straight

up.

CAUTION

It is not necessary to disconnect the

probe from the analog board to re-

move the analog board.

Step 7

Remove the four retaining screws at the corners of the board.

Step 8

Remove the analog board by grasp-

ing the upper left and lower right cor-

ners and pulling the board straight

away from the probe connector.

Gen-

tly rock the board back and forth

slightly to disengage the board from

the probe connector.

CAUTION

Handle the board carefully by

touching only the edges. Do not

bend circuit board components.

GSI TympStar Version 1 and Version 2 Service Manual 5 - 5

Questions and Answers:

Need help?

Do you have a question about the GSi TYMPSTAR Series and is the answer not in the manual?

GSi TYMPSTAR Series Specifications

General