To Next Page

To Previous Page

Calibration

Resolving problems

It is unlikely that you will encounter problems during calibration. However, if you

are unable to meet a calibration objective at any point in the process you must take

corrective action and start the process again from the beginning.

If you encounter a problem-

Check your equipment, test cavities and connections, and start over.

Still have a problem-

Clean the probe or Contra phone, check the probe tubes and start over.

Still have a problem-

Change the probe assembly and start over.

Still have a problem-

Contact your local GSI representative or GSI technical support.

GSI TympStar Version 1 and Version 2 Service Manual 4 - 27

Questions and Answers:

Need help?

Do you have a question about the GSi TYMPSTAR Series and is the answer not in the manual?

GSi TYMPSTAR Series Specifications

General