Chapter 8
Oscillator 1 (Analog Schematic) and Oscillator 2 can be programmed and routed in
this mode. Also the Ipsi and Contra channels can be turned on or off in this mode.
With this combination of oscillator programming/routing and channel control, either
oscillator can be routed to either channel and the desired stimulus can be selected.
This mode, in conjunction with the Routing Mode, enables analysis of all the possible
mixing, routing and available stimulus selections. The channels are turned on or off
with the IPSI ON/OFF and CONTRA ON/OFF softkeys. The selection of oscilla-
tor and stimulus to either channel is accomplished using the IPSI SOURCE and
CONTRA SOURCE softkeys.
Grason-Stadler
To Next Page
Loading...
Need help?
General
