GTS iMAPLA series - Page 61

Page 61 Issue 08/2013
Installation and commissioning
General safety instructions
Warning
Risk of injury
y
When protective coverings are not in use, there is arisk of
injury through electric shock, moving parts and hot surfaces.
► Only operate the iMAPLA system when protective covers
have been tted for the drive as specied.
Warning
Risk of injury and risk of damage!
y
The use of unauthorised third party parts can lead to
malfunctions, damage or danger.
► Only use third party parts expressly approved by the
manufacturer for the installation.
Warning
Risk of injury and risk of damage!
y
Shutting o the drive motor counts as ageneral EMERGENCY
STOP function.
► In the event of an emergency, shutting down the drive
machine can switch o the system safely. After the
shut-down, hazardous voltages may remain in and on the
system for up to amax. 45seconds.
Warning
Risk of injury and risk of damage!
y
Always make sure during installation that the PE/PA
connection (potential connection, usually green/yellow)
between lifting magnet and generator controller is connected
to the electricity supply. Without this, the detection of
external ISO faults in the lifting magnet will not be possible. If
this connection is not present, an installed insulation monitor
may no longer be able to detect an insulation fault.