GW Instek APS-7000 Series - Phase:stop[:Immediate]; [:Source]:Simulation:normal<1|2; [:Source]:Simulation:normal<1|2>:Phase:stop:enable

REMOTE CONTROL
119
Parameter/Return
parameter
<1|2>
Normal 1 or Normal 2
<NR2>
ON Phs (start phase)
MINimum
0
MAXimum
359
Example
:SIM:NORM1:PHAS:STAR 0
Sets ON Phs to 0.
[:SOURce]:SIMulation:NORMal<1|2>
:PHASe:STOP:ENABle
Set
Query
Description
Enables/Disables the OFF Phs parameter of the
normal1 or normal2 step for the Simulation mode.
Syntax
[:SOURce]:SIMulation:NORMal<1|2>:PHASe:STOP
:ENABle {<bool>|OFF|ON}
Query Syntax
[:SOURce]:SIMulation:NORMal<1|2>:PHASe:STOP
:ENABle?
Parameter/Return
parameter
<1|2>
Normal 1 or Normal 2
OFF | 0
Disabled
ON | 1
Enabled
Example
:SIM:NORM1:PHAS:STOP:ENAB 1
Enable the OFF Phs.
[:SOURce]:SIMulation:NORMal<1|2>
:PHASe:STOP[:IMMediate]
Set
Query
Description
Sets or queries the OFF Phs parameter of the
normal1 or normal2 step for the Simulation mode.
Note:
Sets the off phase of the waveform after the output
has been turned off.
Syntax
[:SOURce]:SIMulation:NORMal<1|2>:PHASe:STOP[:I
MMediate] {<NR2>|MINimum|MAXimum}
Query Syntax
[:SOURce]:SIMulation:NORMal<1|2>:PHASe:STOP[:I
MMediate]? [MINimum|MAXimum]
Parameter/Return
<1|2>
Normal 1 or Normal 2
<NR2>
OFF Phs (Stop phase)