GW Instek APS-7000 Series Programming Manual

APS-7000 Programming Manual
34
Configure Ethernet Connection
The Ethernet interface can be configured for a number of different
applications. Ethernet can be configured for basic remote control or
monitoring using a web server or it can be configured as a socket
server.
The APS-7000 supports both DHCP connections so the instrument
can be automatically connected to an existing network or
alternatively, network settings can be manually configured.
Ethernet
Parameters
MAC Address (display
only)
DHCP
IP Address
Subnet Mask
Gateway
DNS Address
DNS Server
Socket port fixed at 2268
Ethernet
Configuration
1. Connect a LAN cable from the PC
to the Ethernet port on the rear
panel.
LAN
2. Press the Menu key. The Menu
setting will appear on the display.
Menu
3. Use the scroll wheel to go to item 5, LAN and
press Enter.
4. If the LAN cable is installed correctly a
connection is active, the Connection Status will
show Online.
5. To automatically have the network assign an IP
address, set DHCP to ON. Otherwise set DHCP
to OFF to manually set the Ethernet settings.
DHCP
ON, OFF

GW Instek APS-7000 Series Specifications

General

Brand	GW Instek
Model	APS-7000 Series
Category	AC Power Distribution
Language	English