APS-7000 Programming Manual
146
-201 Invalid while
in local
Indicates that a command is not executable while
the device is in local due to a hard local control
(see IEEE 488.2, 5.6.1.5); for example, a device with
a rotary switch receives a message which would
change the switches state, but the device is in local
so the message cannot be executed.
Indicates that a legal password-protected program
command or query could not be executed because
the command was disabled.
Indicates that a GET, *TRG, or triggering signal
was received and recognized by the device but
was ignored because of device timing
considerations; for example, the device was not
ready to respond. Note: a DT0 device always
ignores GET and treats *TRG as a Command Error.
Indicates that a request for a measurement
initiation was ignored as another measurement
was already in progress.
Indicates that a program data element related error
occurred. This error message should be used when
the device cannot detect the more specific errors
described for errors -221 through -229.
Indicates that a legal program data element was
parsed but could not be executed due to the
current device state (see IEEE 488.2, 6.4.5.3 and
11.5.1.1.5.).
Indicates that a legal program data element was
parsed but could not be executed because the
interpreted value was outside the legal range as
defined by the device (see IEEE 488.2, 11.5.1.1.5.).
To Next Page
Loading...
Need help?
General
