FAQ
174 A03031_24_E00_01 HBM: public QuantumX
S Check the Scan options in the 'Module suchen' dialog.
S Does your Ethernet switch work properly?
If you are not operating any other devices on the switch with which you can
check the function, try to set up a direct connection between the PC and the
QuantumX module.
S If you want to use the QuantumX module in a larger network, please con
tact your network administrator. There are a series of options in adminis
trated networks to limit or completely prevent data transmission between
individual subscribers. Administrative enabling may also be necessary here.
Operation in LAN
1. No server in the network, the PC has no setting or uses DHCP, the Quan
tumX module has a permanent address
No connection can be set up with this combination.
2. DHCP server in the network, the PC has a permanent address or uses
DHCP, the QuantumX module has a permanent address
A connection can normally only be set up when the PC and QuantumX
module addresses lie in the same subnet, i.e. the IP address may only have
different digit groups where a 0 is present in the subnet mask. Also refer to
Changing the Ethernet interface parameters of the QuantumX
To Next Page
Loading...
