Changed functions with 340 49x-04
HEIDENHAIN iTNC 530 25
Changed functions with 340 49x-04
DCM: Retraction after collision simplified (see "Collision monitoring
in the manual operating modes", page 385).
The input range for polar angles was increased (see “Circular path
CP around pole CC” on page 232).
The value range for Q-parameter assignment was increased (see
"Programming notes", page 296).
The pocket-, stud- and slot-milling cycles 210 to 214 were removed
from the standard soft-key row (CYCL DEF >
POCKETS/STUDS/SLOTS). For reasons of compatibility, the cycles
will still be available, and can be selected via the GOTO key.
The soft-key rows in the Test Run operating mode were modified to
those of the smarT.NC operating mode.
Windows XP is now used on the dual-processor version (see
“Introduction” on page 690).
Conversion from FK to H was moved to the special functions (SPEC
FCT).
Filtering of contours was moved to the special functions (SPEC
FCT).
Loading of values from the pocket calculator was changed (see “To
transfer the calculated value into the program” on page 149).
To Next Page
Loading...
Need help?
General
