HEIDENHAIN iTNC 530 603
16.4 Program Run
16.4 Program Run
Application
In the Program Run, Full Sequence mode of operation the TNC
executes a part program continuously to its end or up to a program
stop.
In the Program Run, Single Block mode of operation you must start
each block separately by pressing the machine START button.
The following TNC functions are available in the program run modes
of operation:
Interrupt program run
Start program run from a certain block
Optional block skip
Editing the tool table TOOL.T
Check and change Q parameters
Superimpose handwheel positioning
Functions for graphic simulation
Additional status display
To Next Page
Loading...
