HEIDENHAIN iTNC 530 619
17.1 Selecting MOD Functions
Overview of MOD functions
The functions available depend on the momentarily selected operating
mode:
Programming and Editing:
îš„ Display software numbers
îš„ Enter code number
îš„ Set data interface
îš„ Diagnostic functions, if applicable
îš„ Machine-specific user parameters, if applicable
îš„ Display HELP files (if provided)
îš„ Select machine kinematics, if applicable
îš„ Load service packs
îš„ Set the time zone
îš„ Start file-system check
îš„ Configure the HR 550 wireless handwheel
îš„ Legal information
Test run:
îš„ Display software numbers
îš„ Enter code number
îš„ Set the data interface
îš„ Show the workpiece in the working space
îš„ Machine-specific user parameters, if applicable
îš„ Display HELP files (if provided)
îš„ Select machine kinematics, if applicable
îš„ Set 3-D ROT function, if applicable
îš„ Set the time zone
îš„ License info
In all other modes:
îš„ Display software numbers
îš„ Display code digits for installed options
îš„ Select position display
îš„ Define unit of measurement (mm/inches)
îš„ Set the programming language for MDI
îš„ Select the axes for actual position capture
îš„ Set the axis traverse limits
îš„ Display reference points
îš„ Display operating times
îš„ Display HELP files (if provided)
îš„ Set the time zone
îš„ Select machine kinematics, if applicable
îš„ License info
To Next Page
Loading...
Need help?
General
