HEIDENHAIN ITNC 530 - CONVERSATIONAL PROGRAMMING - Reset Tcpm Function

HEIDENHAIN iTNC 530 477
12.4 TCPM FUNCTION (Software Option 2)
Reset TCPM FUNCTION
U FUNCTION RESET TCPM is to be used if you want to
purposely reset the function within a program.
Example NC block:
...
25 FUNCTION RESET TCPM Reset TCPM FUNCTION
...
The TNC automatically resets TCPM FUNCTION if you select
a new program in a program run mode.
You can reset the TCPM FUNCTION only if the PLANE function
is inactive. If required, run PLANE RESET before FUNCTION
RESET TCPM.