HID HDP5000 - Page 153

To Next Page

To Previous Page

HDP5000 High Definition Card Printer/Encoder User Guide L000950 Rev 1.8

153

Installing the Flipper Module Accessory

Display A - Slide the Flipper Module attachment tabs and the PCB-INTF Board into the

appropriate slots at the base of Printer Module. This picture shows the Printer and the Flipper

Module.

Main Page

HDP5000 High Definition Card Printer/Encoder User Guide (Rev. 1.8)1
- Table of Contents4
Section 1: Printer Overview10
- HDP5000 Process Flow (in Table Format)10
Section 2: Specifications15
Section 3: Setup and Installation Procedures39
Section 4: Printer Driver Operations67
Section 5: Accessory Procedures149
- Using the Security Lock Slot on the HDP5000149
- Installation and Removal Procedures Flipper Module Accessory151
  - Installing the Flipper Module Accessory152
Section 6: General Troubleshooting154
- Troubleshooting - LCD and Printer Error Message Tables154
- Communications Errors187
Section 7: Ethernet Option Section195
Section 8: Card Lamination Module261
Section 9: Printer Adjustments269
Section 10: Toolbox272
Section 11: Cleaning299
- Using the Required Supplies299
- Accessing the Clean Printer Tab300
Section 12: Fargo Workbench Printer Utility309
- Reviewing the Card Tab and Diagnostic Button309
Section 13: Fluorescent Panel Usage310
- Configuring Fluorescent Data (F-Panel for YMCFK Ribbon) Using the Workbench312
- Configuring Fluorescent Data (F-Panel for YMCFK Ribbon) Using the Application322
Section 14: Inhibit Panel Usage325
- Using Inhibit Panel (Via the Fargo Workbench Printer Utility)325
Section 15: Packing the Card Printer340
Section 16: Firmware Updates341
- Performing the Firmware Updates341
Section 17: HID Global Technical Support347
- Contacting Technical Support347
  - Reading the Serial Numbers on the Printer348
  - Finding out When a Fargo Card Printer was Manufactured348
Section 18: Glossary of Terms349

HID HDP5000 - Page 153

Table of Contents

Related product manuals