HID HDP5000 - Using the Encoder Flip Angle Option; Setting the Printhead Resistance; Using the Transfer TOF Adjustment Option

All rights reserved HID Global Corporation
HDP5000 High Definition Card Printer/Encoder User Guide L000950 Rev 1.8
290
Using the Encoder Flip Angle Option
Use the Encoder Flip Angle option to fine tune the position of the Flipper. (Note: This is
done in relation to the Printer's built-in Encoder if your Printer is equipped with this option.)
Setting the Printhead Resistance
This is factory set. If the main board or the Printhead is replaced then adjust this number.
• Locate the Printhead Setting Number on the bottom of the Printhead.
• The number reads R=XXXX.
Using the Transfer TOF Adjustment Option
Follow this instruction.
Step Procedure
1 Print the alignment card self-test.
2 Adjust the Transfer TOF until the TOF Zero Line is located on the edge of the
card as shown below.