All rights reserved HID Global Corporation
HDP5000 High Definition Card Printer/Encoder User Guide L000950 Rev 1.8
261
Section 8: Card Lamination Module
The HDP5000 supports the attachment of an optional Card Lamination Module. This Module
can be ordered pre-installed on the Printer from the factory or can be ordered separately as a
field upgradeable Module.
Once attached, the Card Lamination Module allows you to apply Fargo certified
overlaminates for more secure, tamper-resistant cards. This section explains all aspects of
the Card Lamination Module's operation and the overlaminate materials available.
See Using the Lamination tab (HDP5000-LC)
.
IMPORTANT! Fargo Card Printers require highly specialized Print Ribbons to function
properly. To maximize Printer life, reliability, printed card quality and durability, you must use
only Fargo Certified Supplies. For this reason, your Fargo warranty is void, where not
prohibited by law, if you use non-Fargo Certified Supplies. To order additional materials,
please contact your authorized reseller.
Printer Unit: Reviewing the Card Lamination Module
Danger: The Printer’s Transfer Roller can reach temperatures exceeding 350° F
(175° C). Use extreme caution when operating the Laminator. Never touch the Transfer
Roller unless the Printer has been turned off for at least 20 to 30 minutes.
Select Printer models support the attachment of an optional Card Lamination Module. This
Module can be ordered pre-installed on your Printer from the factory or can be ordered
separately as a field upgradeable Module.
To Next Page
Loading...
Need help?
General
