All rights reserved HID Global Corporation
HDP5000 High Definition Card Printer/Encoder User Guide L000950 Rev 1.8
86
Adjusting the Film Type
Step Procedure
1 Allows you to select the film type option that is appropriate for the type of
HDP film currently loaded in the Printer.
• Select the Clear option to automatically adjust the appropriate transfer
time and temperature to pre-determined defaults. (Note: Select this
option to automatically adjust the transfer temperature (175.0 Celsius)
and the dwell times (2.0 seconds per inch) to defaults when non-custom
card type is chosen on Card tab.)
OR
• Select the Holographic option to change appropriate internal Printer
settings needed to make the holographic film work. (Note: Select this
option to automatically adjust the transfer temperature (175.0 Celsius)
and the dwell times (2.0 seconds per inch) to defaults when non-custom
card type is chosen on Card tab.)
(Note: It will also adjust the necessary transfer temperature and the
dwell settings in the Driver to provide the optimal holographic InTM
performance.)
To Next Page
Loading...
