HID HDP5000 - Reviewing the Lamination Module Sequence of Operations; Reviewing the Overlaminates

All rights reserved HID Global Corporation
HDP5000 High Definition Card Printer/Encoder User Guide L000950 Rev 1.8
14
Reviewing the Lamination Module Boot-up Sequence
Step Process
1 The Lam Headlift turns until the head up position is returned from Headlift
Sensor.
2 The Lamination Ribbon Motor activates. (Note: The RFID determine the
presence of a roll of lamination.)
3 The Card Sensor checks for the presence of a card and ejects it if found.
Reviewing the Lamination Module Sequence of Operations
The LAM sequence of operations begins after printing has occurred with the Card Printer.
Step Process
1 The card is fed onto the Lamination Module.
2 The card is fed to the Card Position Sensor.
3 The Lamination Take-up Motor begins cycling until the Lamination Sensor
detects the mark.
4 The Card Feed Motor activates to place the leading edge of the card on the Lam
Roller.
5 The Lam Roller Lift Motor cycles until the Transfer Roller Lift Sensor detects the
roller is down.
6 The Card Feed Motor and the Lamination Drive Motor activate for the length of
the card.
7 The Lam Roller Lift Motor cycles until the Lam Roller Lift Sensor detects the
roller is up.