HID HDP5000 User Manual

All rights reserved HID Global Corporation
HDP5000 High Definition Card Printer/Encoder User Guide L000950 Rev 1.8
297
Using the Mag Hi-Co Voltage Offset Option
This option changes the voltage going the magnetic head.
This is factory set and should not be changed unless directed by a technician.
Using the Mag Lo-Co Voltage Offset Option
This option changes the voltage going the magnetic head.
This is factory set and should not be changed unless directed by a technician.
Using the Mag Flipper Angle Offset Option
This option changes the angle of the Flipper Table. Increasing the flipper angle will rotate
the flipper table clockwise. This is factory set and should not be changed unless directed by
a technician.
Using the Lamination Top of Form Option
This option changes location of patch(s) over length of card
Using the Lamination End of Form Option
This option changes head lift at end of card
Using the Lamination Bottom Takeup Option
This option changes tension of Laminate roll 1.
Using the Lamination Top Takeup Option
This option changes tension of Laminate rolls 2 (if equipped)

HID HDP5000 Specifications

General

Print Resolution	300 dpi
Interface	USB
Print Technology	Dye sublimation
Card Capacity	100-card input hopper
Connectivity	USB 2.0
Print Capability	Single-sided
Operating System Support	Windows 7, 8, 10
Card Sizes	CR80 (standard credit card size)