All rights reserved HID Global Corporation
HDP5000 High Definition Card Printer/Encoder User Guide L000950 Rev 1.8
198
Network Management Interface
The SNMP interface is described below.
Interface Description
SNMP
• The Ethernet interface is a fully-manageable SNMP agent that supports
MIB-II.
• The Ethernet interface is MIB II compliant, allowing SNMP managers to
monitor protocol, network and routing statistics.
Telnet Command Line Interface
Initiating a Telnet Session
This procedure shows how to initiate a Telnet session from a PC in order to access the
Telnet services provided by the Printer.
Description
Initiating a
Telnet
session
Follow these instructions to issue Telnet commands.
1. Identify the IP address of your Printer. (Note: See Switching to the
Automatic IP Address Mode.)
2. Initiate a Telnet session from a DOS window on your PC. At the DOS
prompt, enter telnet [IP Address]
• Example: C:\>telnet 192.168.11.12
• All Telnet responses from the Printer will then be displayed in the
Telnet session on the PC.
• All commands entered will be sent to the Telnet client in the
Printer.
3. Enter “help” or “?” to get an on-window list of supported Telnet
commands. .
To Next Page
Loading...
