HID HDP5000 User Manual

All rights reserved HID Global Corporation
HDP5000 High Definition Card Printer/Encoder User Guide L000950 Rev 1.8
70
Selecting the Card Type
Select the appropriate card type according to the composition of the card stock.
Step Procedure
1 You have these selections (to choose from):
• Fargo UltraCard Premium III (Default Card Type)
• Fargo Ultracard
• HID Tech Card Composite
• HID Tech Card PVC
• Indala FlexISO – Standard (FPISO)
• Indala FLexISO XT-Composite (FPIXT)
• Custom 1
• Custom 2
• Defaults: The HDP Printer Driver software has default Transfer
Temperature and Dwell Time settings that deliver the best transfer for
these card types. These defaults automatically configure based on the
card type, Ribbon type and whether printing single- or dual-sided.
• Card Type Selection: Before printing, if using these standard Fargo
card types, check to make sure that the appropriate card type option
selected from the Card tab of the HDP Printer Driver:
• Proper Settings: It is very important to note that not all card types will
be accommodated by these default settings. In some cases,
experimentation may be needed to find the proper settings.
Caution: If the appropriate option is not selected, the wrong Dwell
Time and temperature may be used during the image transfer process, which
may result in poor adhesion of the HDP Film or warping of the card.)

HID HDP5000 Specifications

General

Print Resolution	300 dpi
Interface	USB
Print Technology	Dye sublimation
Card Capacity	100-card input hopper
Connectivity	USB 2.0
Print Capability	Single-sided
Operating System Support	Windows 7, 8, 10
Card Sizes	CR80 (standard credit card size)