EasyManuals Logo

HID HDP5000 User Manual

HID HDP5000
373 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #263 background imageLoading...
Page #263 background image
All rights reserved HID Global Corporation
HDP5000 High Definition Card Printer/Encoder User Guide L000950 Rev 1.8
263
Installing the Card Lamination Module
Introduction
The following guide provides a step-by-step installation procedure for the HDP5000
Lamination Module and Printer Driver Accessory. Refer to the HDP5000 High Definition Card
Printer/Encoder User Guide for details on operating your new card Lamination Module.
The time required for each installation is provided below:
• Lamination Module Installation (time required): This hardware installation process will
require approximately 10 to 15 minutes.
• Driver Software Installation (time required): This software installation process will
require approximately 2 to 6 minutes (depending on the speed of your PC).
Inspecting the Card Lamination Module
While unpacking your Lamination Module, inspect the carton to ensure that no damage has
occurred during shipping. (Note: Make sure that all supplied accessories are included with
your unit.)
Your new Lamination Module is packaged in a standard HDP5000 Card Printer/Encoder
carton. (Note: It is recommended that you save the packaging in the event that you need to
transport the Card Printer/Encoder/Laminator at a future date.)
Unpacking the Card Lamination Module
The following items are included with your new Lamination Module:
• Card Lamination Module
• Power Supply with a Power Cord (for the Card Lamination Module)
• Warranty Card
Choosing a proper Location
Follow these guidelines:
• Place the unit in a location with adequate air circulation to prevent internal heat build-up.
• Use the Printer's dimensions (10.75 H x 35.5 W x 13 D) as a guideline for the minimum
clearances to the unit. (Note: Allow for adequate clearance above the unit to
accommodate the height of the unit with its Covers open.)
• Do not install the unit near heat sources, such as, radiators or air ducts.
• Do not install the unit in a place subject to direct sunlight, excessive dust, mechanical
vibration or shock.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the HID HDP5000 and is the answer not in the manual?

HID HDP5000 Specifications

General IconGeneral
Print Resolution300 dpi
InterfaceUSB
Print TechnologyDye sublimation
Card Capacity100-card input hopper
ConnectivityUSB 2.0
Print CapabilitySingle-sided
Operating System SupportWindows 7, 8, 10
Card SizesCR80 (standard credit card size)

Related product manuals