ID2000 Series Industrial Code Reader User Manual
93
mode is set to Normal mode and the trigger mode is enabled.
Note
The parameter is only available when the running mode is set to Normal mode and the
trigger mode is enabled.
●
Min. Code Length: If the length of a barcode is shorter (in terms of the number of
characters) than the configured value, the device will NOT parse the barcode.
For example, if you set the value to 6, the device will not parse the barcodes which contain
fewer than 6 characters.
Note
The valid value of the parameter is from 1 to 256.
●
Max. Code Length: If the length of a barcode is longer (in terms of the number of
characters) than the configured value, the device will NOT parse the barcode.
For example, if you set the value to 9, the device will not parse the barcodes which contain
more than 9 characters.
Note
The valid value of the parameter is from 1 to 256.
●
Numeral Filter: If enabled, the device will only parse and read the numeral contents of the
barcodes, and the non-numeral contents will be filtered out.
●
Begin with Specific Character for Result: enabled, the device will only read the barcodes
which begin with a specific character string.
●
Begins with: Enter the character string.
●
Include Specific Character in Barcode: If enabled, the device will only read the barcodes
which include a specific character string.
●
Character: Enter the character string.
●
Exclude Specific Character in Barcode: If enabled, the device will only read the barcodes
without a specific character string.
●
Character: Enter the character string.
●
Remove Duplicate By ROI: If it is enabled, the device will filter information based on drawn
ROIs.
●
Read Times Threshold: If the reading results of a barcode is same for the configured
times, the barcode will be regarded as valid and its data will be outputted. Or the barcode
will be regarded as invalid and its data will not be outputted.
●
De-duplication Enable By Trigger: If it is enabled, the repeated code information will be
filtered within specific trigger times. You can set trigger times in De-duplication Windows
Size, and its default value is 1.
●
De-duplication By ROI: If it is enabled, the device will filter information based on drawn
ROIs.
●
Code Start Offset Num: It cuts the specific length of code contents from starting, and the
remaining part will be outputted.
●
Code End Offset Num: It cuts the specific length of code contents from ending, and the
To Next Page
Loading...
