ID2000 Series Industrial Code Reader User Manual
125
Steps
1. Go to Config Management, and find Timing.
2. Click Setting and enable NTP Enable.
3. Set parameters according to actual demands.
Note
Configure NTP server settings before using NTP time synchronization function.
4. Click OK after settings.
Figure 11-2 Set NTP Timing
11.3 Enable Device Auto Work
This function allows the device to automatically enter the operation status after being
powered on.
You can go to Config Management → Device Auto Work Enable, and enable Device Auto
Work Enable.
Figure 11-3 Enable Device Auto Work
To Next Page
Loading...
