ID2000 Series Industrial Code Reader User Manual
86
Steps
1. Right click the device in Device Connection, and click Feature Tree.
2. Go to Trigger and IO Control→ Buzzer Enable, and enable Buzzer Enable.
Note
After enabling Buzzer Enable, the buzzer beeps three times when the device is powered on,
beeps twice when the device reads setting codes successfully, and beeps once when the
device reads codes successfully.
3. Set Buzzer Duration (ms) and Buzzer Frequency (hz) according to actual demands.
Figure 9-43 Set Buzzer
9.8 Communication Settings
The communication protocol is used to transmit and output code reading result and image.
The communication protocol is related to the device modes. With various device modes, the
device supports different communication protocols and corresponding parameters.
●
If the device’s operation mode is Test or Raw, and it only supports SmartSDK protocol
and no parameter settings are required.
●
If the device’s operation mode is Normal, and it supports SmartSDK, TCP Client, Serial,
FTP, TCP Server, Profinet, MELSEC/SLMP, Ethernet/IP, ModBus, UDP, Fins and USB
communication protocols, and you need to set corresponding parameters.
Note
●
The supported communication protocols may differ by device models.
●
Type VII device supports SmartSDK, USB and Serial only. Regarding other device types,
the device with USB data interface supports SmartSDK and USB only, and device with fast
Ethernet supports all communication protocols apart from USB.
●
The specific parameters of communication protocols may differ by device models.
9.8.1 Set SmartSDK
If you select SmartSDK as the communication protocol, you can configure the following
parameters:
To Next Page
Loading...
