EasyManua.ls Logo

HikRobot ID2000 Series - Chapter 4 Connector and Cable; Device with Fast Ethernet Interface

HikRobot ID2000 Series
140 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
ID2000 Series Industrial Code Reader User Manual
11
Chapter 4 Connector and Cable
This section introduces the device’s connector, including fast Ethernet interface, USB
interface and RS-232 interface, and the supplied cable in the package.
Note
The device’s connector and connector pin definitions may differ by device models.
4.1 Device with Fast Ethernet Interface
Device with fast Ethernet interface includes type I, type II, type III, type IV, type V, and type VI
devices.
Type II and Type V Devices
Both type II and type V devices have a 17-pin M12 connector, but their corresponding
connector pin definitions are different. Refer to the figure and table below for details.
Figure 4-1 17-Pin M12 Connector
Table 4-1 Pin Definitions (Type II Device)
No.
Signal
I/O Signal Source
Description
Supplied Cable
1
DC_PWR
--
Direct current power
supply positive
Red open line
2
GND
Line 0/1/3/4-
signal ground
Signal common port
Brown open line
3
Reserved
4
RS232_TX
--
RS-232 serial port output
DB9 female serial port
5
RS232_RX
--
RS-232 serial port input
DB9 female serial port

Table of Contents

Related product manuals