ID2000 Series Industrial Code Reader User Manual
73
2. Click to start acquisition, and the client software will display specific code score in
the history record area.
Figure 9-27 Code Score
3. (Optional) Go to Image Settings, and adjust parameters like exposure time, gain, Gamma,
light source, etc. if the code score is low.
Note
If the code score is still low after adjusting, and the code may have poor printing quality.
9.5 Line Mode Settings
Line mode settings allow you to customize the specific line as input or output according to
actual demands.
Go to I/O Control Settings → Line Mode Control, and set Input or Output according to
actual demands.
Note
●
Only the vari focal device (type I, type II and type III devices) supports this function.
●
If the device has 4 bi-directional I/Os, and Line 0 and Line 1 are input, and Line 2 and Line
3 are output by default.
●
Line 0 should be same with Line 1 as input or output, and Line 2 should be same with Line
3 as input or output.
Figure 9-28 Set Line Mode
To Next Page
Loading...
