ID2000 Series Industrial Code Reader User Manual
63
●
1D Code: 1D code types added in field of view will be self-adaptive.
●
2D Code: 2D code types added in field of view will be self-adaptive.
●
Stacked Code: Stacked code types added in field of view will be self-adaptive.
5. (Optional) Set light source parameters in Lighting Mode.
●
Light Adapt: The client software will select the best one from all lighting options during
the self-adaptive adjustment.
●
Current Light Adapt: The client software will use the current configured light source.
●
All Light Disable: All light sources will be turned off during self-adaptive adjustment
process.
6. Click Execute in Adjust Start. The device will automatically acquire images and perform
self-adaptive adjustment, and stop acquisition after adjustment is completed.
Note
If the adjustment completed, the client software displays the spent time and prompts
adjustment succeeded. If the adjustment failed or is timeout, the client software prompts
adjustment failure or timeout.
9.3.7 Set Test Pattern
Test pattern helps troubleshooting image problems and images in the test pattern are only
for test. When exceptions occur in images acquired by the device in real time, you can check
if images in the test pattern have similar problems to determine the cause of an exception.
Note
●
The test pattern is available in the test or raw operation mode.
●
Specific parameters of this function may differ by device models.
Go to Image Settings, click All Features, find Test Pattern in Other Features, and set Test
Pattern according to actual demands.
Figure 9-17 Set Test Pattern
To Next Page
Loading...
