HikRobot ID2000 Series - Main-Sub Networking

ID2000 Series Industrial Code Reader User Manual
90
Table 9-14 Ethernet/IP Communication Protocol
Parameter
Description
Ethernet/IP Enable
If enabled, the code reader will output data via
Ethernet/IP protocol.
9.8.9 Set ModBus
If you select Modbus as the communication protocol, you can configure the following
parameters:
Table 9-15 ModBus Communication Protocol
ModBus
Description
ModBus Enable
If enabled, the code reader will output data via ModBus
protocol.
ModBus Mode
Select a mode from Server and Client.
ModBus Control Space
The value is "holding_register" by default and not editable.
ModBus Control Offset
Offset of the control address. The default value is 0.
ModBus Control Size
The value is 1 by default.
ModBus Status Space
It sets status space and it is “holding_register” by default.
ModBus Status Offset
It sets status offset and it is 1 by default.
ModBus Status Size
It is 1 by default.
ModBus Result Space
It set result space and it is “holding_register” by default.
ModBus Result Offset
It is 2 by default.
ModBus Result Size
It is 100 by default.
ModBus Result Byte Swap
If it is enabled, the client software will swap ModBus
results.
ModBus Result Timeout (s)
It sets the result timeout of the ModBus protocol.
9.8.10 UDP
If you select UDP as the communication protocol, you can configure the following
parameters: