ID2000 Series Industrial Code Reader User Manual
43
7.3 Set Device Network and Connect to Client Software
You can set and operate the device in the client software only when the device is in the same
network segment with the PC where the client software is installed.
Steps
1. Double click the client software to run it.
2. Click to find the device.
3. Right click the device to be connected, and click Modify IP.
4. Set the IP address of the device in the same network segment with the PC, and click OK.
Figure 7-4 Modify IP Address
5. Double click the device in device list or click to connect it to the client software.
6. (Optional) Go to Device Control and enable Preventing Illegal Occupation to prevent IP
address being occupied by other devices.
7. (Optional) Go to Device Control and enable Force IP Enable if you want to edit static IP
address.
Figure 7-5 Preventing Illegal Occupation and Force IP Enable
To Next Page
Loading...
