ID2000 Series Industrial Code Reader User Manual
56
Type VII Device
Steps
1. Go to Image Settings → Light, and select Lighting Mode according to actual demands.
2. Enable Laser Enable according to actual demands.
3. Enable Laser Delay Enable, and enter Laser Delay Duration to delay the close time of the
laser after the device stops triggering.
Figure 9-8 Set Light Source (Type VII Device)
9.3.4 Set Smart Tune
The smart tune function allows you to adjust the device’s focus position, exposure, gain, etc.
by one-key operation, and supports self-adaptive adjustment.
The smart tune function has two methods to be realized, including smart tune by pressing
tune button and smart tune via the client software.
Smart Tune by Pressing Tune Button
Note
●
The parameters of the smart tune may differ by device models and firmware versions.
●
During the process of smart tune, the focus parameters and self-adaptive parameters will
be adjusted in turn.
Steps
1. Go to Image Settings, click All Features on the right corner, and find Smart Tune Control.
2. Enable Button Tune, and disconnect the device from the client software.
Figure 9-9 Button Tune
To Next Page
Loading...
