ID2000 Series Industrial Code Reader User Manual
57
Note
Smart tune by pressing the tune button is not supported if the device is connected via the
client software.
3. Hold the tune button for 3 sec and the device starts smart tune.
●
During smart tune process, the status indicator flashes in green and red colors
alternatively.
●
If smart tune succeeds, the status indicator is solid green lasting 3 sec and then restores.
●
If smart tune fails, the status indicator is solid red lasting 3 sec and then restores.
4. (Optional) Hold the button for 3 sec again during smart tune process, and the smart tune
will be cancelled.
Smart Tune via Client Software
Apart from pressing tune button to realize smart tune, you can also configure parameters
via the client software to realize it.
Before You Start: Make sure that the device is not in trigger mode, and its operation mode
is test.
Steps
1. Go to Image Settings, click All Features on the right corner, and find Smart Tune Control.
Figure 9-10 Smart Tune Control
2. (Optional) Set Tune Timeout. If the self-adaptive adjustment exceeds configured value,
and it will stop automatically.
3. Click Execute in Smart Tune Start to let the device start smart tune, and a window of
smart tune will be displayed for you to view the effect.
To Next Page
Loading...
