HikRobot ID2000 Series - Output Signal Wiring

ID2000 Series Industrial Code Reader User Manual
37
6.2.5 Output Signal Wiring
Note
● Output signal wiring may differ by external device types.
● The supplied cable has pull-up and pull-down resistors.
● The voltage of VCC should be equal to or less than that of PWR. Otherwise, the output
signal exception may occur.
PNP Device
None-isolated
Output
DB9 Connector
PNP
Device
PNP Device Power
PNP Power Ground
Signal Line
VCC
GND of VCC
Figure 6-28 Output Signal Connecting to PNP Device (Other Devices Apart from Type VII)
None-isolated
Output
USB Interface/DB9 Serial Port
PNP
Device
PNP Device Power
PNP Power Ground
Signal Line
VCC
GND of VCC
Type VII
Device
Figure 6-29 Output Signal Connecting to PNP Device (Type VII Device)
NPN Device
Other devices apart from type VII device use the pull-up resistor of the supplied cable, the
wiring is shown below.
DB9 Connector
NPN
Device
NPN Device Power
VCC
GND of VCC
Internal Resistor
of Cable
None-isolated
Output
Signal Line
NPN Power Ground
●
Figure 6-30 Output Signal Connecting to NPN Device (Pull-Up Resistor of Cable Used)